Menu
‹ Chapter 159 of 206 ›

Spasmodic Workers

2 min read · Chapter 159 of 206

THEY are like the steam-engine before Watt took it in hand. Watt was not the inventor of that marvellous machine, but he might as well have been, for any good it did before his time. Not that it "would not go," it went often most unexpectedly, and in most eccentric ways. The fault was that it worked by fits and starts, and the reason was that while Newcomen, its inventor, had discovered how to make the piston rise in the cylinder, he did not know how to send it down again. It had to drop when the steam which sent it up had condensed; and in order to produce condensation more quickly, he managed to inject cold water into the cylinder, while the piston was up, which of course brought it down more quickly than it went up; but this process had another effect, viz., that of cooling the cylinder; and, then, there had to be a fresh heating of the cylinder before the piston would rise again. So the thing went on, the engine suddenly starting off, and then feeling the cold water, as

475

suddenly stopping, or only going so long as the momentum of its first impulse lasted. Of course there was no work got out of a machine like that.

There are plenty of human engines after the Newcomen model. Fire their zeal by a rousing sermon, and they are off before you can say Jack Robinson; but, suddenly, they stop: they have felt the cold water, and oh! what a "warming up" it takes to get them "off again." It is astonishing to see how they subside, how they fail you when you are depending on them most.

Mr. Watt found out the remedy for the spasmodic engine, and it was this:— He first attached a side pipe to the cylinder into which the steam might escape, and then be condensed, without cooling the cylinder. Then he brought to bear upon the piston a second pressure from above, thus working it by a double process, viz., power from below and power from above. In this way we got the real working engine, and all its splendid achievements followed.

My fitful friend! it is not that you have no zeal; you have too much at times. You need a reserve pipe. You boil over, and put your own fire out. You start with too much energy at first, and then there's no time to get up steam again before you stop. Now, let me advise you. Put the rein on before you start, mature your plans, look ahead, see all the difficulties before you begin: expect the cold water too (for lots of engines work in the wet). It is the unexpectedness of difficulty that brings you to a standstill; but, if you foresee it, you will say, when it comes, "Ah! yes, I've been looking out for you, I'm ready, you can't cool me, I've got my waterproof on." So on you go steadily and perseveringly doing real work. Then may I add that while there must be the under-pressure, the strength of body, the willingness, the common sense, and all that belonging to yourself, you must also have the power from above, the love of Christ constraining you, the energizing influence of the Holy Spirit, which not only enables you to work with grand results, but gives your work that which nothing else can give it, acceptance in the sight of the great Framer of us all.

A DEACON.

Everything we make is available for free because of a generous community of supporters.

Donate